One term that home inspectors need never use is "grandfathered." It's a term that refers to a building component or installation that was acceptable at the time it was done, but is no longer acceptable on new installations. A very common, simple example of this is the allowable spacing on balusters at guards. At one time the allowable spacing was 9 inches, then it was reduced to 6 inches, and was reduced again to 4 inches, which is where it stands today.
When home inspectors point out wide spacing at balusters, we're doing so because it's a safety issue. It doesn't matter when the home was built, because we're not there to do a code-compliance inspection. In other words, the term "grandfathered" should never come up during a home inspection, because it doesn't matter.
Conversely, home inspectors need not get hung up on new code requirements just because they're now code. Take for example the entire new Minnesota plumbing code that just recently went into effect. With this new code came a ton of changes to the way things were always done. For example, the old minimum required floor space for a shower was 900 square inches, but now it's 1,024 square inches.
Do changes like this matter to a home inspector? No. Have I ever measured/calculated the floor space of a shower to make sure that it met code? Heck no. What would I say if a shower was short by 10 square inches? Tear it out and redo it? No way. Not unless I could justify doing so without using the word code. I'm not a code inspector, and I'm not there to report code violations; I'm there to report stuff that matters. I have no aversion to using the word "code" during my inspections and in my reports, but it's not what I base my reports and recommendations on. It's just something I can use if I need an authoritative source to back up my recommendations.
